(Opening) Have you ever encountered a "Primer Bulb"? It may seem like a highfalutin piece of equipment, but it actually gets small machines to run better and more efficiently. In this lesson, we will take a look at how and why primer bulb fuel pumps are so important for a small engine; how they work, how you can replace them when they go bad, and how to fix some common issues that may arise. Knowing such things can help you maintain and troubleshoot equipment as it gets older.
What is a primer bulb fuel pump? Primer bulb fuel pumps provide power to small engines that need help getting fuel to start. This function creates suction and provides lift, which pulls the fuel from the fuel tank and into the engine when needed. The primer bulb is simply a small rubber ball that can be pressed by hand. This tool works so with Built to fit in places around small carburetors that are tough to reach, a few presses of the bulb fills with gas and creates a suction effect. That is why it is referred to as a "primer" bulb, as it primes the engine with fuel to assist in starting.
Examples of Primer Bulb Fuel Pumps for Small Engines The biggest advantage is they help start the engine much easier. Pressing the primer bulb pumps fuel into the carburetor. This makes it easier, especially when it’s cold outside or the engine has not been used in a long time, to start the engine.
A lot of times when an engine doesn't start right away it will crank over and the pistons will compress fuel but they don't have any fuel to compress. Hard starting makes the engine work much harder than necessary. Eventually, this additional work can cause issues and ruin the engine, which can be expensive to fix. To prevent engine failure, you should try to assist your engine to start properly with the help of a trimmer primer bulb.
Primer bulb fuel pumps are like any tool or device: Sometimes they have a problem. The most common problem is that dirt, dust or other debris can clog the fuel lines. Its inability to flow properly through the pump can prevent the engine from starting. To fix this issue, clean the fuel lines using a small brush and if the lines are too dirty, consider replacing with new ones.
If you need to replace or replace a primer bulb in your equipment, you are not off! That being said, it is not too hard and can be done by yourself through some simple methods. Identifying the fuel lines between the fuel tank and the carburetor Once you find those you should, with a gentle touch, disconnect the fuel lines from the pump, which can be deeper inside your machine, and then remove the old pump.
Then, take the new pump and mount it in the same location as the old pump. Ensure that it snugs into place and the fuel lines are properly connected to the new pump. It will work properly 하면 하라 뭐 it it it it this this this Lastly, to make sure it works, you will want to pump the primer bulb a couple of times. This is to make sure the gasoline is going properly into the motor.
EN
AR
BG
HR
CS
DA
NL
FI
FR
DE
EL
HI
IT
JA
KO
NO
PL
PT
RO
RU
ES
SV
TL
IW
ID
LT
SR
SK
SL
UK
VI
ET
MT
TH
TR
FA
MS
AZ
KA
LA
